Fairing
Now I am in the process of fairing the boat. It seems to be quite a long and slow process. Fairing is when you shape and trim frame members to form a bevel that will allow the side planking to have a flat surface to mate to across the entire boat. Having no clue where to begin I attempted to use the Rabl method as mentioned in the Glen L Boatbuilding with Plywood book. Even then it was difficult to acquire the right angles in the bevel. I decided to jump right in having no idea if what I'm doing is right!

 Fairing demonstration from Boatbuilding with Plywood by Glen L.


Starting on one side hoping that when I get to the other side I'll have a better idea of what I'm doing.


This is where I am at now. I'll try to keep this updated more frequent as I move further along. Which could be a while.

Comments

Post a Comment

Popular posts from this blog

Image
Fiberglassing It's exciting every time I get to the next stage of building the boat. After filling the screw holes with famowood and using system three QuickFair to smooth out the scarf joints in the panels it is time to start fiberglassing. I sanded down all of the sharp corners of the boat, mainly around the chines and transom because the fiberglass won't bond well to sharp angles. It will end up creating air bubbles on the corners witch we really don't want. I used the fiberglass kit from Glen-L. I couldn't find any instructions on how to use which fiberglass sheet where, so I finally decided to use one sheet to cover the bottom of the boat and the transom. Then trimmed it to size. I invited some friends out to help in the process. Much easier to do with extra hands than by yourself. When dealing with epoxy and having to work quickly it is nice to have someone to mix the epoxy and multiple people to poor and smooth out the epoxy into the fiberglass weave....
Read more
Image
Encapsulating the Frames My next task was to encapsulate the frames using epoxy. This helps protect the wood from moisture and rot. Everything I've read says 2-3 coats, with 3 coats being ideal. I'm using the MAS epoxy resin and Low-Tox hardener sold on the Glen-L website. I've read great things about that epoxy so ordered the MAS instead of Glen-L's poxy-shield. I thought encapsulating the frames before I mount them to the building form would be a fairly simple task...I was wrong. The First coat went on without any problems. There was quite a bit of bubbling but this is normal and a good sign that the epoxy has seeped into the wood pours and the air has surfaced to the top. I applied the first coat at night to some of the frames and the next morning it was still quite tacky. My plan was to allow each coat to cure then sand it and apply another coat, but with the cure time of this mixture that would take forever. So, I set up some heat lamps and that really spe...
Read more
Image
Bottom Planking Prior to top planking, I put in some corner braces along the chine and transom and made some timbers in the battens near the transom. Instead of using a router or some fancy power tool I just used a wood rasp and smoothed it out with sandpaper and it turned out pretty nice. Timbers are small cutouts to allow water to pass through to one area of the boat. In this case it will allow most the water that gets in the boat to pool up near the middle of the transom. When I take the boat out of the water I can just sponge up any water remaining in the boat before it is stored. I know some people will go crazy about this but I decided to not put in a drain plug. The benefits don't seem to out way the risks. I could completely mess up the angle when drilling through the transom, not only that but it's probably more likely to rot there first. The only time I'd ever use it is when the boat is on the trailer and I want to drain water out. Which from what I've read ...
Read more